Crown Trade – FastFlow Quick Dry Satin Finish – White – 1l & 2.5L
Silky smooth Fastflow Quick Dry Satin Finish in White, is a water-based, durable satin finish for use on suitably prepared interior and exterior joinery and metalwork.
FastFlow Quick Dry Satin Finish has an excellent opacity, and a fabulous smooth, attractive finish.
It has all the characteristics of a traditional solvent based satin, with the added benefits of a water based formulation, including quick drying and low odour.
Fastflow Quick Dry Satin Finish is available in:
Colour Range – White
Packaging – 1, 2.5 and 5 litre.
Drying Time:
In good conditions, Fastflow is touch dry after 1-2 hours and recoatable in 4-6 hours.
Ensure the previous coat is fully dry though before applying a second coat.
At low temperatures or high humidity, drying times may be extended.
Finishes to a satin sheen.
Water based
Spreading Rate:
Fastflow Satin Finish can cover to 15m² per litre depending on surface texture.
Limitations:
Do not apply when air or substrate temperatures are likely to fall below 8°C or when the relative humidity is above 80% during application or the drying period.
How to prepare new surface timber and timber based boards (Including MDF):
Treat any knots with two coats of fresh knotting first.
Fill any fixing holes, open joints and shallow surface defects with a Ready Mixed Filler.
Rub down with a suitable grade of abrasive sandpaper.
Remove all dust.
All surfaces must be suitably dry, and free from anything that will interfere with the adhesion of the materials to be applied.
Prime with one coat of Crown Trade Fastflow Quick Dry Primer Undercoat.
All metals:
Surfaces must be clean and free from anything that will interfere with the materials to be applied.
Lightly abrade to a bright (not polished) surface – excluding galvanised surfaces.
Wash with hot water and liquid detergent solution to remove oil, grease or any other contaminants, frequently changing the water.
Rinse thoroughly with clean water.
Allow to dry.
Fastflow coverage:
For best results apply two coats of Fast Flow Quick Dry Satin.
Newly painted doors and windows should not be closed until the paint is fully dry.
How to Apply Fastflow Quick Dry Satin Finish:
Stir well before use.
Apply using a good quality synthetic brush or a good quality micro fibre medium pile roller, to achieve an even thickness.
To assist application on porous substrates the surface may be dampened slightly.
Maintain a wet edge.
On timber lay off in the direction of the grain.
Avoid excessive de-nibbing in-between coats.
For airless spray dilution may be required.
Cleaning your brushes/rollers:
Clean equipment with water immediately after use.
French 
English