Rustins – Quick Dry Indoor Varnish – Satin – 250ml 500ml & 1L

Rustins – Quick Dry Indoor Varnish – Satin

Rustins – Quick Dry Indoor Varnish – Satin is a clear, water-based acrylic varnish.
It gives long lasting protection to all internal wood, allowing the natural grain to show through.
The varnish looks milky-white whilst liquid but dries to a hard, durable transparent finish, which makes it resistant to water and alcohol.

Intended Use:
Interior, bare woodwork, cork, hardboard.
It can also be used as a sealer for concrete, brickwork and plaster.

Special Features:
Low odour, quick-drying, non-yellowing on ageing.
Wash brushes in water directly after use.
The varnish has very little effect on the colour of wood to which it is applied, allowing the original grain to show through.
Conforms to Safety of Toys Regulations BS EN 71 Part 3 1995.

Preparation:
Surfaces must be clean and previous coatings should be removed with Rustin’s Strypit Paint and Varnish Stripper.
It is advisable though, to clean old surfaces with White Spirit to remove any wax or contamination, wipe away the solution formed with clean kitchen paper towels.

Applicationr
Use a synthetic brush, varnish Roller or spray (can be diluted with water about 10% if necessary for spraying, or if the temperature is high).
Coats 2 or 3. Lightly sand after 1st coat to flatten any raised grain.

Drying Time – Touch dry in 20 minutes typically, depending on temperature and humidity.
Re-coating Time – Re-coat after 2 hours
Application Temp. –  Ideally 15-25°C, do not use below 10°C or in conditions of high humidity.
Coverage –  12-15sq.metres/litre per coat, depending on absorbency of surface.

Maintenance:
The varnish will take 3 days to fully harden, so treat gently for the first few days.
Spills should be wiped-up immediately during this time to prevent damage.
The surface can be cleaned as required with a mild detergent solution, do not use aggressive cleaning products.
Re-coat the varnish as necessary, after cleaning and lightly sanding the surface.

Compatibility:
Can be applied over either Rustin’s Wood Dye, other brands may be incompatible.
Bare wood may be bleached with Rustin’s Wood Bleach prior to varnishing.
Not for use over scumbles or oil-based paints.
Other types of coatings/stains may be incompatible, including acrylic paints and vinyl emulsion.
If using anything other than Rustin’s Wood Dye, a test area should be coated to determine compatibility.

Settlement:
Stir well before use.
Satin and Matt finishes may dry glossy if not thoroughly stirred, check for settlement on the bottom of the tin and stir to mix-in.

Shelf-life/Storage – Many years if stored in normal conditions. Protect from frost.